top of page

After the installation where to go ?


This application is divided into 5 Boxes, that are in fact active button !

INSTALL CURL FOR WINDOWS

RM COMMANDER BUILDER TOOLS need CURL for windows to works
CURL, will be the motor of this application, CURL will send all the commands to the ANDROID RM BRIDGE, that will convert all the commands and send them to the RM2 Pro

By pressing on the INSTALL CURL For WINDOWS, the application will test if CURL.exe, and it Librairy is install inside c:\CURL folder of your computer
If CURL is installed, this function will not change anything
If CURL isn't installed, you will be invited to download CURL, 32 or 64 bits
Just download the right one and then install manually CURL in c:\curl folder, and anywhere else or RM COMMANDER BUILDER TOOLS will not works at all .

Nothing else to do at this step
 

IDENTIFICATION on the NETWORK

As said previously the application RM COMMANDER BUILDER TOOLS will need to etablish a connection with ANDROID RM BRIDGE, and also with the RM2 Pro

This will be done by pressing on this button box

It will be ask you to enter the IP adress of your ANDROID RM BRIDGE
It's the bridge that have been installed on your android TV BOX, or on your PHONE

This adress appear on the screen of your TV BOX, or on your PHONE, when you start the ANDROID RM BRIDGE application ( this ANDROID application must be download, installed, started, without authentification , and with the port 7474)

You will need to enter the full IP Adress, in the format aa.bb.cc.dd.ee:7474

Where aa.bb.cc.dd.ee is the IP adress, and 7474, the port adress

 

Don't forget the 2 points between IP adress and PORT adress

Nothing else to do at this step

CREATE IR or RF CODE

We enter now in the purpose of this application, create infrared code, or radio code ( 433 mhz, and  315 mhz )

Just press on this button box and just answer to the questions

You will fist see an information box ( code IR or RF learning)


Don't press the OK key now


The application is waiting that you press on a remote key, the remote key that you want to record


Then press on the remote key that you want to record (on your remote unit), quicky, and not too long time ( if you press too long time the code received will be too long, and will not be valid), about 1 second .

 

The code will be between 8 to 15 lines for a normal Radio Code

Now press  the OK key (on the screen )

You will see the code inside an information window, that is the code that have been received by the RM COMMANDER BUILDER TOOLS

Press the OK key on the screen

Now, you will have to fill (enter), the name that you want to give to your code ( one name, by code )
Don' give any extension to the name, or the code will be valid


Then press again on the OK key on the screen

Nothing else to do at this step
 


TEST a CODE

As in the title , this Button box, is a command to test the codes, that you did recorded previously

There is no difficulty for this level

Fill ( enter), the name of the code that you want to test, and press on the OK key on the screen

If your record code is valid, this function will replicate, the command of your remote key

Nothing else to do at this step

 

EXIT COMMANDER TOOL

As in the tiile of this button box

Press on the button box, to exit the application
 

bottom of page